- #Step 7 siemens timers flash tutorials serial
- #Step 7 siemens timers flash tutorials Pc
- #Step 7 siemens timers flash tutorials download
#Step 7 siemens timers flash tutorials Pc
With the CP5512 and PC Adapter cables, you should use the MPI port, as this is the default connection for Siemens. If not double-check the connection and cable. Once the proper interface is selected and the properties are set then click OK and use the Accessible Nodes window to check for successful communications. Also, check under the Local Connection tab and make sure connection selection matches the port the cable is connected into. It should not conflict with existing PLC and slave devices on the network. This will discover working settings and use them automatically.įor the PC Adapter click on the Properties button and make sure the Station Parameters Address is a unique network address. To get it working quickly it is best to select the interface with the Auto designation.
Be careful not to select your wireless Ethernet connection. For Ethernet select the TCP/IP interface for your computers network card. communication drivers).Įach cable has its own interface. The following dialog box will open up displaying all the different interfaces (i.e. To do this, select the menu Options > Set PG/PC Interface. In order to start communication to the PLC you will need to match the "PG Interface" setting with the programming cable and protocol. This indicates that the cable is not in the right computer port or the cable is not plugged in properly. If communication fails then you will receive a message like below.
#Step 7 siemens timers flash tutorials download
If so, then close the Accessible Nodes window and proceed to the download or upload section.
If communications are successful, you'll see a window pop up similar to the one below. With the programming cable plugged in, you can check for proper operation by clicking on the Accessible Nodes icon.
The CP5512 card draws its power from the computer.įor Ethernet (TCP/IP) use a standard Ethernet cable from the computer to a CPU with an Ethernet port, a CP 343/443 module or a network switch all ready attached to the PLC network. Be aware that the PC Adapter draws its power to work from the connection port so check the power LED for proper operation. These cables can piggyback on existing connectors. Note that PROFIBUS is labeled as DP on the Siemens connection ports. The CP5512 card and the PC Adapter can communicate on either an MPI or PROFIBUS port.
#Step 7 siemens timers flash tutorials serial
The PC Adapter using a serial or USB connection There are three major types of programming cables:Ģ. Connecting to the S7 PLC The Programming Cables
0 kommentar(er)
